®
Washer
PRODUCT MODEL NUMBERS
RECESSED AREA OR CLOSET INSTALLATION
WTW5100V
WTW5200V
WTW5300V
WTW5505V
WTW57ESV
WTW58ESV
WTW5590V
WTW5790V
If a closet door is installed, the minimum ventilation openings in the top and bottom of
the door are required (view 3). Louvered doors with equivalent air ventilation openings in
the top and bottom are acceptable.
"
"
Electrical: A 120-volt, 60-Hz, AC-only,
"
15- or 20-amp, fused electrical supply is required.
A time-delay fuse or circuit breaker is
"
recommended. It is recommended that a separate
circuit serving only this appliance be provided.
"
"
"
"
"
"
"
"
1
2
3
Front view
Side view
Closet door with vents
DRAIN SYSTEM OPTIONS
Standpipe drain system - wall or floor (view 1 & 2)
The standpipe drain requires a minimum diameter standpipe of
2 in. (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39 in. (99 cm) high
and no higher than 96 in. (244 cm) from the bottom of the
washer.
IMPORTANT: To avoid siphoning, no more than 8" (20.3 cm) of
drain hose should be inside the standpipe.
Laundry tub drain system (view 3)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39 in.
(99 cm) above the floor and no higher
than 96 in. (244 cm) from the bottom
of the washer.
Floor drain system (view 4)
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28 in. (71 cm) from the bottom of the
washer. Additional hoses might be
needed.
39"
(99 cm)
28"
(71 cm)
39"
(99 cm)
3
4
1
2
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10200331C
09-26-08
|